Datcon DT9100 B, Operating Instructions Manual

Page: 21 / 63

DT9100 B
5.3. Connecting the digital outputs
A DT9100 B digital output is an output for the direct driving
of another clock synchronising input or a NAMUR input.
You may connect an instrument to the output if its input is
in conformity with the following output parameters:
Uo < 10 V, Io < 200 mA, Po < 0.5 W.
The following figure shows the connection:
Wiring plan, connecting
the digital outputs
(see also “Application
example”)
Be careful with the polarity
of the cables.
1. Push the cable end into the terminal assembly as far as
possible. By pushing the wire in, the self-closing connection
is being established.
2. Check it by pulling it outwards slightly.
20180905-V1
21