Datcon DT9100 B, Operating Instructions Manual

Page: 39 / 63

DT9100 B
7.10. Digital output 2 (08. menu item)
Function Out 2 digital output mode setting.
Sequence of operations 1. Enter the menu by typing in the supervisor code.
The way the code should be typed in is described in
Chapter 7.1. Type in the code (password)
. You will see on
the display:

.
2. Keep stepping by pressing the ▲ button until the menu
item

.
3. Enter the menu item by pressing the ENTER button.
4. You will see

mnemonic on the display. The
mnemonic will be blinking.
5. By pressing the
ENTER button you can read the active
digital output mode.
6. Press the ▲ button to select the desired output mode:
•


= output in OFF state [Factory setting]
•


= repeating synchronisation input signal.
With this function, you can synchronise an other DT9100 B
clock.
•


= output is in ON state.
Exit from the menu item 1. After finishing the setting, press the MENU button, to exit
the menu item, and you will see this:

.
(2. If you want to change the setting you have just done, or
if you just want to check what you have typed in, go on with
the operation from point 3 of the
Sequence of
operations .)
(3. If you don’t want to exit the menu, as you want to do
further settings, then you may select the desired menu
items by pressing the ▲ button.)
Exit from the menu
1. Press the MENU button. First the mnemonic

( Save ), then the mnemonic

( Exit ) will be shown on
the display. With that, the storing of the settings is
completed. The instrument has exited the menu and goes
on with the measurement.
20180905-V1
39