Datcon DT9100 B, Operating Instructions Manual, Page: 14 / 63

DT9100 B
Mounting the instrument Four M3 threaded screws are needed for mounting the
instrument (these are not accessories). The type of the
screws depends on the wall-material, while their
dimensions depend on the wall-thickness. The use of
cross
recessed pan head
screws is recommended to make the
mounting easier. The minimum screw-length should be the
wall-thi 10 mm.
During mounting, please observe all safety rules, and use
only appropriate tools.
Secure the screws against getting loose. For this purpose
you may use spring lock or serrated lock washers.
Depending on the material of the wall, and in order to
ensure the most practicable mounting method, it is not
mandatory, of course, to use the above-described threaded
joints. Depending on the situation, special screw types for
wood or for metal sheets can also be used, or the joint can
be riveted too.
Mounting back the front
cover 1. Check if there are foreign objects left in the housing, like
small tools, wire or metal pieces, plastic chips, etc. If there
are, remove them.
2. Put back the front cover of the instrument, taking care
that the sealing should get to its place. There should be no
gaps or cables left between the housing and the front
cover.
3. Tighten the front cover.
Turn the screws in clockwise direction. Tighten the screws
as much as necessary to ensure the desired sealing.
14
20180905-V120180905-V1