Datcon DT9100 B, Operating Instructions Manual

Page: 32 / 63

DT9100 B
7.4. Time-set (02. menu item)
Function Setting the time (hour : minute) without second clearing.
Sequence of operations 1. Enter the menu by the user or the supervisor code.
The way the code should be typed in can be found in
Chapter 7.1. Type in the code (password). You will see on
the display:

.
2. Keep stepping by pressing the ▲ button until the menu
item

appears.
3. Enter the menu item by pressing the ENTER button.
4. You will see the

on the display, and first digit will
be blinking.
5. Pressing the ▲ button you can increase the value of the
blinking digit:

,

,

,

,

,

,

,

,

,

, etc.
•
By pressing the ► button you can select the next digit, so
you can set all the four digits. (after the 4th digit the 1st
digit will appear).
Exit from the menu item 1. After finishing the settings, press the MENU button to
exit the given menu item, and then you will see this:

.
(2. If you want to change the setting you have just done, or
if you just want to check what you have typed in, go on with
the operation from point 2 of the
Sequence of
operations. )
(3. If you don’t want to exit the menu (you want to make
further settings), then you may select the desired menu
items by pressing the ▲ button.)
Exit from the menu
1. Press the MENU button. First the mnemonic

( Save ), then the mnemonic

( Exit ) will be shown on
the display. With that, the storing of the settings is
completed. The instrument has exited the menu and goes
on with the measurement.
32
20180905-V120180905-V1