Datcon DT9100 B, Operating Instructions Manual

Page: 54 / 63

DT9100 B
10.7. Setting the time (example)
Function Time set.
Enter the menu
1. Press the MENU button. You will see the

mnemonic on the display. The mnemonic will be blinking.
2. You will see:

on the display. The left digit will be
blinking.
•
By pressing the▲ button you can increase or decrease
the selected digit:

,

,

,

,

,

,

,

,

,

, etc.
•
Press the ► button to select the next digit.
3. By pressing the ▲ and ► buttons you can type in the
supervisor code.
4. Press the
MENU button. If you have typed in the correct
code you will see the

(enter as user) or

(enter as supervisor) mnemonics for 2.5 seconds, after that
you will see the

on the display.
5. Entering bad code, the

( B ad C ode = bad code)
mnemonic will appear on the display for 2.5 seconds, than
the instrument exits this menu and the clock goes on
working.
Begin the time setting from point 1.
Setting the seconds
6. Enter the

menu item by pressing the ENTER
button.
7. You will see the mnemonic

on the display for
2.5 seconds, and then the time appears in MM.SS format.
The decimal point will be blinking.
8. Press the ▲ button to set the seconds to zero.
Seconds will be rounded down between 0 and 29 seconds,
and they will be rounded up between 30 and 59 (11:59.25 »
11:59.00 or 11:59.37 » 12:00.00). This function can be
used if the time hasn’t been set, then you will se

on
the display, or when the time isn’t accurate.
54
20180905-V120180905-V1