User Manual
UMN:CLI
V8102
87
ly operated.
Step 1
Configure a slot for the specified IU type, use the following command.
Command
Mode
Description
slot planning iu SLOT_NUMBER
{
siu-gpon16
|
sfu-10ge4
}
Global
Specifies an IU type in a slot.
SLOT_NUMBER : the slot number of IU
(e.g. X | X-Y)
If a slot was configured with a specified IU type, and the system has detected that a dif-
ferent type of IU is physically inserted in this slot, the equipped IU cannot be activated in
the system.
Step 2
Change the admin state to
‘unlock’ for each slot to activate the equipped IU.
Command
Mode
Description
slot unlock iu SLOT_NUMBER
Global
Unlocks a particular slot.
SLOT_NUMBER : the slot number of IU (e.g. X | X-Y)
To lock a particular slot for preventing the abnormal operation, use the following com-
mand.
Command
Mode
Description
slot lock iu SLOT_NUMBER
Global
Locks a particular slot. (default)
SLOT_NUMBER : the slot number of IU (e.g. X | X-Y)
5.2.2
IUs Replacement
The procedures in this section replace IU to another one. The configuration of IU
’s re-
placement is a five-step process:
Step 1
Lock the existing IU in a slot that you want to replace.
To lock a particular slot, use the following command.
Command
Mode
Description
slot lock iu SLOT_NUMBER
Global
Locks a particular slot. (default)
SLOT_NUMBER : the number of IU slot (e.g. X | X-Y)
Step 2
Remove the existing IU from the slot, use the following command.
Command
Mode
Description
no slot planning iu SLOT_NUMBER
Global
Removes the registered IU from the
slot.
!
