Dalsa Spyder3 SC-30-02K80-00-R, User Manual

Page: 69 / 111

Spyder3 Color Manual 69
DALSA 03-032-20059-01
Mnemonic Syntax Parameters Description
set system gain
ssg
i
Set the digital gain.
i
= Digital gain in a range from
0
to
65535
. The digital video values are
multiplied by this number.
set user set
number
sus
i
set upper
threshold
sut
i
The pixels equal to or greater than the
upper threshold are checked for and
reported in the end-of-line sequence in a
range from
0
-
4095
.
set video mode svm
i
Switch between normal video mode and
camera test patterns:
0
: Normal video mode
1
: Camera test pattern
2
: Camera test pattern
Update color
reference ucr Set the color reference value to the current
color gain value.
verify temperature vt Check the internal temperature of the
camera.
verify voltage vv Check the camera‘s input voltages and
return OK or fail.
write FPN
coefficients wfc Write all current FPN coefficients to non-
volatile memory.
write PRNU coeffs wpc Write all current PRNU coefficients to
non-volatile memory.
write user settings wus Write all of the user settings to non-
volatile memory.
4.20 Error Handling
The following table lists warning and error messages and provides a description and
possible cause. Warning messages are returned when the camera cannot meet the full
value of the request; error messages are returned when the camera is unable to complete
the request.
Table 15: Warning and Error Messages
Message Description
OK> SUCCESS
Warning 01: Outside
of specification> Parameter accepted was outside of specified operating range (e.g. gain
greater than 0 to +20 dB of factory setting).
Warning 02: Clipped
to min> Parameter was clipped to the current operating range. Use
gcp
to see
value used.
Warning 03: Clipped
to max> Parameter was clipped to the current operating range. Use
gcp
to see
value used.