Dalsa Spyder3 SC-30-02K80-00-R, User Manual

Page: 36 / 111

36 Spyder3 Color Manual
03-032-20059-01 DALSA
Setting the Exposure Time
Purpose: Sets the camera‘s exposure time is µs. Camera must be operating in
exposure mode 2, 6, or 8.
Syntax:
set f
Syntax Elements:
i
Desired exposure time in µs. Allowable range is
3
to
3300
µs.*
Notes:

To read the current line frequency, use the command gcp or
get set
.

If you enter an invalid line rate frequency, an error message is
returned.

*The exposure time range is based on the current line rate.

To determine the maximum exposure time allowed for the
current line rate, use the command
get ger .
Related Commands:
sem, ssf
Example:
set 400.5
Setting the Pixel Readout Direction (Mirroring
Mode)
Purpose: Sets the tap readout from left to right or from right to left. This
command is especially useful if the camera must be mounted
upside down.
Syntax:
smm i
Syntax Elements:
i
Readout direction. Allowable values are:
0 =
All pixels are read out from left to right.
1 =
All pixels are read out from right to left.
Notes:

To obtain the current readout direction, use the command
gcp
or
get smm
.

This command is available in both TDI and Area Mode.

Refer to the following figures and tables for an explanation of
pixel readout and mirror direction.

Refer to the section below for the sensor architecture diagrams
that illustrate the sensor readout direction.
Example:
smm 1
Figure 16: Left to Right Readout (smm 0) Forward Direction Example Output
Figure 17: Right to Left Readout (smm 1) Forward Direction Example Output
i
Applies to Modes 2 and
8