Dalsa Spyder3 SC-30-02K80-00-R, User Manual

Page: 13 / 111

Spyder3 Color Manual 13
DALSA 03-032-20059-01
Note: Camera performance specifications are not guaranteed if your power supply does not meet
these requirements.
DALSA offers a power supply with attached 6‘ power cable that meets the Spyder3 Color
camera‘s requirements, but it should not be considered the only choice. Many high
quality supplies are available from other vendors. Visit the http://mv.dalsa.com Web site
for a list of companies that make power supplies that meet the camera‘s requirements.
The companies listed should not be considered the only choices.
2.4 Camera LED
The camera is equipped with a red/green LED used to display the operational status of
the camera. The table below summarizes the operating states of the camera and the
corresponding LED states.
When more than one condition is active, the LED indicates the condition with the highest
priority. Error and warning states are accompanied by corresponding messages further
describing the current camera status.
Table 6: Diagnostic LED
Priority Color of Status LED Meaning
1 Flashing Red Fatal Error. For example, camera temperature is too
high and camera thermal shutdown has occurred.
Warning. Loss of functionality (e.g. external SRAM
failure).
2 Flashing Green Camera initialization or executing a long command
3 Solid Green Camera is operational and functioning correctly
4 Solid Red Warning. Loss of functionality.
2.5 Camera Link Data Connector
Figure 6: Camera Link MDR26 Connector
MDR26 Female
1
14
13
26
Mat ing Part :3M 334-31 series
Cable: 3M 14X26-SZ LB-XXX-0LC **
The Camera Link interface is implemented as Base Configuration in the Spyder3 Color
cameras. Refer to section on
Error! Reference source not found. for details on setting the
Camera Link configuration.
**3M part 14X26-SZLB-XXX-0LC is a complete
cable assembly, including connectors.
Unused pairs should be terminated in 100
ohms at both ends of the cable.