Daitsu FDLA-09, Installation, Operation & Service Manual

Page: 86 / 322

Auto Fan Speed D.7.
COOL MODE HEAT MODE
Fan speed cannot change until it has run for more
than 30 seconds.
Fan speed is regulated according to the profile
below.
Fan speed cannot change until it has run for more
than 30 seconds.
Fan speed is regulated according to the profile
below.
Swing/Louver D.8.
For remote handset with Control Box – I (Integrated Full Control Version)
Whenever the indoor fan is running, the louver can swing or stop at the desired position.
Louver angle: 0~100 º, opens clockwise with widest angle at 100 º.
Swing angle: 35~100 º, opens clockwise to 68º. Below are the 4 fixed positions which can be set from
wireless LCD handset.
Position Angle against vertical
1 35 º
2 57 º
3 83 º
4 100 º
For wired wall pad with Control Box – I (Integrated Full Control Version)
Louver angle: 0~100 º, opens clockwise, with widest angle at 100 º.
Swing angle: 35~100 º, opens clockwise to 68º. User may stop louver at any desired position between
35~100 º.
Buzzer D.9.
If a command is received by the air conditioner, the master unit will respond with 2 beeps for each
setting, while the slave unit will respond with 1 beep.
Auto Restart D.10.
The system uses non ‐ volatile memory to save the present operation parameters when system is turned
off or in case of system failure or cessation of power supply. Operation parameters are mode, set
temperature, swing louver’s position, and the fan speed. When power supply resumes or the system is
switched on again, the same operations as previously set will function.
On/Off Switch On The Front Panel D.11.

This is a tact switch to select Cool → Heat → O ff opera on mode.
High
Tr
Medium
Low
Low
Ts+3C
Ts+2C
Ts+1C
Ts
High
Medium
Low
High
Tr
Low
Low
Medium
Ts
Ts ‐ 1C
Ts ‐ 2C
Ts ‐ 3C
Low
Medium
High