Daitsu FDLA-09, Installation, Operation & Service Manual

Page: 301 / 322

Page 52 of 73
SK2015 FSTDC ‐ V/P ‐ ECM ‐ 001
Holding Register table:
Description Address Type* Remark
Mode setting 300000 R/W
Cooling mode = 01(H)
Humidify mode = 02(H)
Fan mode = 04(H)
Heating mode = 08(H)
Auto mode = 10(H)
Fan speed setting 300001 R/W
Low speed = 04(H)
Medium speed = 02(H)
High speed = 01(H)
Auto fan speed = 07(H)
Louver swing setting 300002 R/W
Position 1 = 01(H)
Position 2 = 02(H)
Position 3 = 03(H)
Position 4 = 04(H)
Auto = 0F(H)
Stop = 00(H)
Setting temperature 300003 R/W 16~30 degree C (actual*10 format)
Address setting 300004 R Set by dip ‐ switch, reading only
Reset 300005 W =0x33 reset error
Week 300006 W
Calibration wired wall pad and set
timer function
Hour 300007 W
Calibration wired wall pad and set
timer function
Minute 300008 W
Calibration wired wall pad and set
timer function
Second 300009 W
Calibration wired wall pad and set
timer function
Hours in Timer on 300010 R/W Timer ON
Minute in Timer on 300011 R/W Timer ON
Hours in Timer off 300012 R/W Timer OFF
Minute in Timer off 300013 R/W Timer OFF
Icon of Timer ON or OFF 300014 R/W
BIT0 = Icon of Timer ON
BIT1 = Icon of Timer OFF
1 = enable
0 = disable
Super low speed rpm 310000 R/W 200~1500
Low speed rpm 310001 R/W 200~1500
Medium speed rpm 310002 R/W 200~1500
High speed rpm 310003 R/W 200~1500
RPM setting 310004 R/W 0~2000 (used to test
，
0 = disable)
Temperature sampling time 310005 R/W 2~100, default:5S
Factor of auto fan speed 310006 R/W 2~150, default:20
Factor of modulating valve 310007 R/W 2~250, default:150
* R = read only, W = write only, R/W = read and write.