Instruction
SiEN12-710A
86
Operation Manual
ATTENTION
"
To use ON TIMER operation
•
Check that the clock is correct.If not, set the
clock to the present time.
1. Press “ON TIMER button”.
6:00
is displayed.
blinks.
2. Press “TIMER Setting button” until the
time setting reaches the point you like.
•
Every pressing of either button increases
or decreases the time setting by 10
minutes. Holding down either button
changes the setting rapidly.
3. Press “ON TIMER button” again.
•
The TIMER lamp lights up.
"
To cancel the ON TIMER operation
4. Press “CANCEL button”.
•
The TIMER lamp goes off.
"
To combine ON TIMER and OFF TIMER
•
A sample setting for combining the two timers is shown below.
•
TEMP
ON/OFF
POWERFUL
MODE
FAN
SWING
SENSOR
ECONO
MOLD PROOF
TIMER
ON
CANCEL
OFF
QUIET
2
1, 3
4
(Example)
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m
ON TIMER at 7:00 a.m
Combined
"
In de following cases, set the timer again
•
After a breaker has turned OFF.
•
After a power failure.
•
After replacing batteries in the remote control
Summary of Contents for 2MKS40FV1B
