cytiva 29038437, Operating Instructions Manual

Page: 109 / 212

6.4 Calibration
Introduction
This section describes the procedures used to perform calibration of the pumps and
other parts in ÄKTA flux s.
When to use these procedures
It is recommended to perform calibrations before each run.
Allowed user performed calibrations:
•
Pump flow rate for installed pumps
•
Tank level
•
Re-zero function of installed pressure sensors
•
Motor RPM range calibration for installed motors (pumps and mixer)
Allowed service performed calibrations:
•
All user allowed calibration
•
Full range calibration of installed pressure sensors
The pressure and tubing dimension used when calibrating the system should always
correspond to the pressure and tubing dimension used when performing a run.
In this section
Section See page
6.4.1 Calibration of the feed pump 110
6.4.2 Calibration of the transfer pump 115
6.4.3 Calibration of the permeate pump 120
6.4.4 Calibration of the pressure sensors 125
6.4.5 Motor control 126
6.4.6 Tank level 127
6 Run preparations
6.4 Calibration
ÄKTA flux s Operating Instructions 29046893 AG 109