![background image](http://html1.mh-extra.com/html/cybex/xp4010/xp4010_installer-user-manual_2703692044.webp)
3 8
For HP Workstations with BNC Video Connectors
1. Your computer interface cables for this computer will be labeled either
CWI3C-
x
or CWI3F-
x
, depending on the options you ordered. Use the
cable diagrams below to locate the correct cable.
2.
Power down your computer
, then plug the cable's keyboard, PS/2 mouse
and BNC video connectors into the matching ports on the workstation. The
mouse connector is denoted by a yellow band around its cable.
If you have the CWI3F-
x
series cable, you will have three additional
connectors: two 3.5mm connectors for a microphone and speakers, and a
9-pin D-shaped serial connector for a serial port. The microphone connector
is denoted by a blue band around its cable. Plug these connectors into the
appropriate ports on your workstation or peripheral device.
3. Attach the computer interface cable to the XP4000 Series unit by plugging
the 44-pin connector into the rear of the appropriate computer interface
module. Ensure that the connector is firmly seated, then tighten the
thumbscrews.
For XPAB modules using the optional ReBoot xP
To attach your ReBoot xP to your XPAB computer interface module, see the
section “The ReBoot xP” in Chapter 11.
KEYBOARD
PS/2 MOUSE
(yellow band)
SERIAL PORT
PS/2 MOUSE
(yellow band)
MICROPHONE
(blue band)
SPEAKERS
CWI3F-
x CABLE
CWI3C-
x CABLE
BNC VIDEO
BNC VIDEO
KEYBOARD