3 2
AC INPUT
90-240 VAC, 47- 63 Hz
1 AMP FAST BLOW
250 VAC
AVAILABLE SLOTS FOR OPERATION MODULES
AVAILABLE SLOTS FOR OPERATION MODULES
LCI MODULE (FRONT ACCESS MODEL ONLY)
LCI MODULE (FRONT ACCESS MODEL ONLY)
Installing the XPAC/XPAB modules
1. Position the XP4000 Series unit so that the rear panel is facing you. Choose
an available slot. An available slot will have a solid panel covering the
opening, with no connectors showing through it.
NOTE:
For front access models, the LCI module, at the far left of the unit
(viewed from rear), is covered by a solid panel but
IS NOT
an available
slot. Only the LCI module is installed in this slot.
2. Remove the panel covering the available slot by unscrewing the two
Phillips-head screws on the rear of the unit that hold the panel in place.
3. Slide the new computer interface module gently into the open slot until the
44-pin connector lines up flush with the back of the unit.
4. Retighten the holding screws completely. DO NOT overtighten.
5. Fill out the XPAC/XPAB Configuration Chart in Appendix A for each
module as you install it.
Follow this procedure for every computer interface module in your system.
Switch 4
Setting
Off
1 second (default)
On
10 seconds
Time
Keyboard/Mouse Time-out
While multiple consoles can view a computer's video at the same time, only
one station can have keyboard and mouse control at a time. The amount of time
that a console's keyboard and mouse must be inactive before another console
can take control is called the time-out. See the table below for the available
time-outs that can be configured.
Note: Once your XPAC/XPAB module has been installed, you can change the
DIP switch setting at any time through a simple hot-key sequence. See
Chapter 9, Advanced Operations for more information.
