![background image](http://html1.mh-extra.com/html/cybex/xp4010/xp4010_installer-user-manual_2703692085.webp)
7 9
The following notational conventions appear throughout this manual to
illustrate commands for operating your XP4000 Series unit. Whenever you see
one of the symbols listed on the left side of the table, substitute the
corresponding steps or values listed on the right side of the table.
Keyboard
Control
Convention
Key Sequence or Value
Enter Command Mode:
<CM>
1.Press and hold down the ‘Num Lock’ key.
2.Press and release the minus (-) key on the numeric keypad.
3.Release the ‘Num Lock’ key.
(Note: for alternate command mode sequences, see the section,
“Keyboard Switching with Different Cybex Products” in Chapter 9)
<Enter>
Press the ‘Enter’ or ‘Return’ key. The
<Enter>
command is used to
execute an instruction and exit from Command Mode.
Addr
Enter the letter that corresponds to the channel you wish to select.
[channel list]
A channel list can be a
single channel
address (See above)
or
an
address range
, consisting of the low address followed by the high
address separated by a backslash, entered as
[Low Addr\High Addr].
<ESC>
Press the ‘Escape’ key. The
<ESC>
command is used to exit
Command Mode without executing an instruction.