![background image](http://html1.mh-extra.com/html/cybex/xp4010/xp4010_installer-user-manual_2703692027.webp)
2 1
Installing the computer interface modules (XPAL) with a Sun
Follow steps 1-5 of the XPAB and XPAC installation instructions on page 19
and then proceed with the following steps:
6.
Place the LongView Transmitter near the remote computer that you wish
to connect to your XPAL. Connect the Cybex custom cable (marked
CUFC) to the 25-pin INPUT connector on the rear of the Transmitter.
7.
Unplug the peripherals (keyboard, mouse, monitor, speakers, micro-
phone and serial device if applicable) from your computer.
8.
If needed, plug the 13W3 male video adapter into the video port on
back of the Sun workstation.
9.
Install the 8-pin mini-DIN male adapter into the keyboard/mouse port
on the back of the Sun workstation.
10. Plug the CUFC cable into the appropriate connectors of the VAK-1
adapters.
11. Plug the 15HDD male adapter into the video port on the back of your
LongView receiver.
12. Plug the 6-pin mini-DIN male adapter into the keyboard and mouse
ports on your LongView receiver.
13. Plug the monitor and Sun keyboard/mouse cables into the VAK-1 adapters.
14. Power your XP4000 Series unit, LongView Receiver and Sun computer
on. Keyboard and mouse should work normally.
15. Once this is done, select the XPAL from your XP4000 Series unit. Type
the following command, <CM>SW15=0<Enter>.
16. Reselect the XPAL and type <CM>SW16=1<Enter>
Follow this procedure for every XPAL in your system.