142
Key Sequence
Action
<CM>
KM
nnn
<Enter>
Sets the highest unit address that the system will scan
through during a session. Substitute
nnn
with a value from
1 to 254. Required for expansion systems only.
<CM>
KM0
<Enter>
Resets scanning to include channels in the local unit only.
<CM>
TG
<Enter>
Enables the Broadcast Go command
<CM>
TH
<Enter>
Enables the Broadcast Halt command
<CM>
T+
[channel list]
<Enter>
Enables the Broadcast Add Channel (+) command
<CM>
T-
[channel list]
<Enter>
Enables the Broadcast Remove Channel (-) command
<CM>
FOLLOW
Addr
<Enter>
Sets the address of the leader console to be followed
<CM>
<Enter>
Enables Follow Mode
<CM>
FOLLOW-
<Enter>
Disables Follow Mode
<CM>
SWAP
Addr
<Enter>
Sets the address of the console to be swapped with
<CM>
SWAP+
<Enter>
Enables Swap Mode
<CM>
SWAP-
<Enter>
Disables Swap Mode
<CM>
X
Addr
<Enter>
Places a computer channel in Privacy Mode
<CM>
SAVE
<Enter>
Saves user console configuration (i.e. Broadcast Mode,
DIP switch settings, KeyScan channels) settings to
permanent memory. Any configuration changes not saved
will not be retained after a power reset.
<CM>
SW=
n
<Enter>
Overrides DIP switch settings on XPAC/XPAB computer
interface modules. Sets the bank of switches (1-8) to a
user specified ON/OFF combination. To determine the
correct DIP switch code for your system (
n
), refer to
Appendix H.
<CM>
SW+
<Enter>
Enables override of DIP switch settings.
<CM>
SW-
<Enter>
Disables override of DIP switch settings.
<CM>
CHASSIS=
n
<Enter>
Changes the unit address of the local unit to
n
(0-254).
Used in expansion systems only. If your chassis does not
contain either an XPXT or an intelligent power supply
(XPPS-2), you will need to use this command to assign the
chassis a unit address. Valid chassis addresses are
necessary for proper upgrading of expansion systems.
<CM>
SUN=
n
<Enter>
Foreign Sun Workstations Only
Sets all XPAC/XPAB
computer interface modules attached to Suns to emulate
country-specific key codes. To determine the correct code
for your system (
n
), refer to your Sun workstation
documentation and Appendix G.
<CM>
SUNI=
n
<Enter>
Foreign Sun Workstations Only
Sets the current XPAC/
XPAB computer interface module (Sun only) to emulate
country-specific key codes. To determine the correct code
for your system (
n
), refer to your Sun workstation
documentation and Appendix G.
