105
The following commands are used for system control and maintenance. Enter
the command sequences to perform the actions described in the table below.
Key Sequence
Action
<CM>
RESET
<Enter>
Resets the active user module.
<CM>
RESET
Addr
<Enter>
Resets any module in the system, computer or user.
Replace
Addr
with the address of the module to reset.
<CM>
OFF
<Enter>
Logs a secondary user off of the XP4000 system. User
screen goes blank. Video channel is freed up for other users
in the system. Selecting a channel re-enables the user.
<CM>
M+
<Enter>
Re-enables the mouse on the current active channel. Use
after switching the type of mouse connected to a user
station, or after the RESET command has been used on
the active computer interface module.
<CM>
SAVE
<Enter>
Saves user console configuration (i.e. Swap Mode, Follow
Mode) settings to permanent memory. Any configuration
changes that are not saved will not be retained after a
power reset.
<CM>
SW=
nn
<Enter>
Overrides DIP switch settings on XPAC/XPAB computer
interface modules. Sets the bank of switches (1-8) to a user
specified ON/OFF combination. To determine the correct
DIP switch code for your system (
n
), refer to Appendix G.
Further instructions can be found on page 113.
<CM>
SW
n
=1
<Enter>
Overrides DIP switch (
n
) and sets it to the ON position.
<CM>
SWn=0
<Enter>
Overrides DIP switch (
n
)
and sets it to the OFF position.
<CM>
SW+
<Enter>
Enables override of DIP switch settings.
<CM>
SW-
<Enter>
Disables override of DIP switch settings.
<CM>
CHASSIS=
n
<Enter>
Changes the unit address of the local unit to
n
(0-254).
<CM>
SUN=
n
<Enter>
Non-US Sun Workstations Only
Sets all XPAC/XPAB
computer interface modules attached to Suns to emulate
country-specific key codes. To determine the correct code
for your system (
n
), refer to your Sun workstation
documentation and Appendix H.
<CM>
SUNI=
n
<Enter>
Non-US Sun Workstations Only
Sets the current XPAC/
XPAB computer interface module (Sun only) to emulate
country-specific key codes. To determine the correct code
for your system (
n
), refer to your Sun workstation
documentation and Appendix H.
Advanced Operations
9
System Control
& Maintenance
