![background image](http://html1.mh-extra.com/html/cybex/xp4010/xp4010_installer-user-manual_2703692018.webp)
1 2
For PS/2-style keyboard, monitor and PS/2 mouse
1. Your user interface cables for these peripherals will be labeled either
CPIU-
x
or CPIUF-
x
, depending on the options you ordered. Use the cable
diagrams below to locate the correct cable.
2. At your secondary console, plug your PS/2-style keyboard, PS/2 mouse
and monitor connectors into the matching connectors on the user interface
cable. The mouse connector is denoted by a yellow band around its cable.
If you have the CPIUF-
x
series cable, you will have three additional
connectors: two small connectors for a microphone and speakers, and a 9-
pin D shaped serial connector for a serial port. The microphone connector
is denoted by a blue band around its cable. Plug your peripheral connec-
tors into the matching connectors on the user interface cable.
3. Attach the user interface cable to the unit by plugging the 62-pin connec-
tor into the rear of any available secondary console module. Ensure that
the connector is firmly seated, then tighten the thumbscrews.
VGA VIDEO
KEYBOARD
SPEAKERS
MICROPHONE
(blue band)
SERIAL PORT
PS/2 MOUSE
(yellow band)
KEYBOARD
VGA VIDEO
PS/2 MOUSE
(yellow band)
CPIU-
x CABLE
CPIUF-
x CABLE
NOTE:
You may use your SGI, RS/6000 or HP workstation monitor with an
XP4000 Series unit if it will function with all of your attached computers/
workstations. See “Using Non-multisync Monitors” later in this chapter.