![background image](http://html1.mh-extra.com/html/cybex/xp4010/xp4010_installer-user-manual_2703692114.webp)
108
Serial Port
Advanced
Operations
(for XPRB
Modules)
Your XPRB unit has a serial port on the rear panel that can also be used to obtain
a configuration report of your XP4000 system or to download system
enhancements and new product features that you have received from Cybex.
This section covers these advanced applications of the serial port and how you
may utilize them through the XPRB module of your XP4000 system. If you do
not have an XPRB module, see the previous section, “Serial Port Advanced
Operations (for XPLU/XPDU and LCI Modules).”
To accomplish the following procedures, you must have use of a computer not
currently attached to your XP4000 system with terminal emulation software
and a serial port. Connect the included flat RJ-45 cable between the serial port
of your unattached computer and the XPRB module as shown below.
Main Menu
1) Display chassis configuration
2) Display Flash ROM status
3) Download local to remote Flash ROM
4) Download Serial Port to Flash ROM
5) Reboot computer
6) Automatic Flash Upgrades
7) Search for Connected Chassis
Enter your selection:
Run your terminal emulation software as usual. Adjust your setup to the
following:
(9600 or 19200) Baud,N,8,1
flow control = none
The interface on the unit will sync up to the rate that you want to run at. Press
the ENTER key until you are prompted to set the baud rate. The Configuration/
Upgrade main menu shown below should now be on your screen.