![background image](http://html1.mh-extra.com/html/cybex/xp4010/xp4010_installer-user-manual_2703692036.webp)
3 0
J5
J6
J4
J2
J3
J1
2
3
1
J1
J3
J5
J6
J4
J2
5
6
4
2
3
1
2 3
1
*
5
6
4
2
3
1
2 3
1
*
5
6
4
2
3
1
2 3
1
*
5
6
4
2
3
1
2 3
1
*
5
6
4
2
3
1
2 3
1
*
Attaching
a Sun
Workstation
Before you connect your Sun to the XP4000 Series unit, you will need to
configure and install your computer interface module. Both the XPAC and
XPAB modules have one set of jumpers and one DIP switch to configure.
Follow the steps below to configure each XPAC or XPAB module that will be
connected to a Sun workstation.
Configuring your computer interface (XPAC/XPAB) modules
Configuring the Jumpers
The jumpers on the XPAC/XPAB module are used to control the video
selection settings. The default is IBM VGA/SVGA video.
Orient your XPAC/XPAB module so that the 44-pin connector is to your right.
Locate the jumpers on the lower right corner of the board. The XPAC will
contain JP1 - JP6; the XPAB will only have jumpers JP1 - JP5. Configure your
XPAB module as you would an XPAC, ignoring all references to JP6. Use the
diagrams below to configure the video settings for the Sun workstation that
you will attach to this computer interface module. You may wish to consult
your computer or video card reference manual for the video rates supported by
your computer.
44-PIN CONNECTOR
DIP-SWITCH
ASSEMBLY
VIDEO
JUMPERS
IBM VGA/SVGA
(default)
SUN
1152 x 900 @76 Hz
SUN
1152 x 900 @76 Hz
SUN
1152 x 900 @66 Hz
SUN
1600 x 1280 @76 Hz
SUN
1280 x 1024 @76 Hz
XPAC module shown
* XPAC Modules only