![background image](http://html1.mh-extra.com/html/cybex/xp4010/xp4010_installer-user-manual_2703692040.webp)
3 4
J5
J6
J4
J2
J3
J1
2
3
1
J1
J3
J5
J6
J4
J2
Attaching a
Hewlett-
Packard
Workstation
Some older Hewlett-Packard workstations use an HIL interface for the keyboard
and mouse. If your system uses HIL and you do not have an HIL to PS/2
adaptor, you may purchase one by contacting:
Modular Industrial Computers
6025 Lee Highway Suite 140
Chattanooga, TN 37421
Part # HIL-100
Phone (423) 499-0700
Fax (423) 892-0000
Before you connect your HP Workstation to the XP4000 Series unit, you will
need to configure and install your computer interface module. Both the XPAC
and XPAB modules have one set of jumpers and one DIP switch to configure.
Follow the steps below to configure each XPAC or XPAB module that will be
connected to an HP Workstation.
Configuring your computer interface (XPAC/XPAB) modules
Configuring the Jumpers
The jumpers on the XPAC/XPAB module are used to control the video
selection settings. The default is IBM VGA/SVGA video. If your XPAC/
XPAB module is not already set for the default, orient the board so that the 44-
pin connector is to your right. Locate the jumpers on the lower right hand
corner of the board. The XPAC will contain JP1 - JP6; the XPAB will only
have jumpers JP1 - JP5. Configure your XPAB module as you would an XPAC,
ignoring all references to JP6. Set your jumpers to the default as shown below,
and proceed to the DIP switch settings.
XPAC module shown
44-PIN CONNECTOR
DIP-SWITCH
ASSEMBLY
VIDEO
JUMPERS
IBM VGA/SVGA
(default)
* JP6 in XPAC Modules only
*