Cupra ATECA, Owner'S Manual, Page: 313 / 380

Towing bracket device*
●
Never press the
›››
Fig. 250 button when
there is a trailer hooked to the vehicle or
when a carrier system or other accessories
are mounted on the tow hook.
●
If the tow hook is not attached properly,
do not use it. Instead, go to a specialised
workshop and have the towing bracket
checked.
●
If you detect any fault in the electrical
system or in the towing bracket, contact a
specialised workshop and ask them to
check it.
●
If the ball has a diameter of less than 49
mm at any one point, do not use the towing
bracket under any circumstances.
CAUTION
If you clean the vehicle with high-pressure
or steam devices, do not point the jet di-
rectly towards the retractable tow hook or
the trailer power socket, as this may dam-
age the joints or remove the grease neces-
sary for lubrication.
Note
At extremely low temperatures, the tow
hook may be impossible to operate. In this
case, place the vehicle in a warmer location
(for example, a garage).
Fitting a bicycle carrier on the retract-
able towbar
The maximum allowed weight of the carrier
system, including the load, is
75 kg . The car-
rier system should not protrude more than
700 mm backwards from the spherical head.
Only carrier systems on which up to 3 bikes
can be mounted are allowed. Heavier bicy-
cles must be mounted as close to the vehicle
as possible (tow hook).
WARNING
The incorrect use of the tow hitch with a bi-
cycle rack mounted on the tow hook can
cause accidents and injury.
●
Never exceed the maximum weight or
the limits indicated above.
●
The bicycle rack may not be mounted to
the neck of the hook below the ball be-
cause, due to the shape of the neck and
depending on the rack model, the rack
could be incorrectly mounted on the vehi-
cle.
●
Always read and take the manufacturer
assembly instructions into account.
CAUTION
If the maximum weight and limits indicated
above are exceeded, the vehicle may suffer
considerable damage.
●
Never exceed the values indicated!
Note
CUPRA recommends removing, as far as
possible, all removable parts of the bicycles
before setting off. These parts include, for
example, baskets and saddlebags, child
seats or batteries. This improves aerody-
namics and the centre of gravity of the rack
system.
311