Cupra ATECA, Owner'S Manual, Page: 227 / 380

Operating modes
● Place your mobile device in the middle of
the pad with the screen facing up
›››
Fig. 196
›››
.
Make sure there are no objects between the
pad and the mobile phone.
The mobile phone will start charging auto-
matically. For further information about
whether your mobile device supports Qi
technology, check your phone's user manual
or visit the CUPRA website.
“Mobile Signal Amplifier”
The “Mobile Signal Amplifier” allows you to
reduce the radiation in your vehicle and en-
joy better reception.
For safety reasons, it is recommended that
you pair the system and the mobile using
Bluetooth
® and place it on the Connectivity
Box pad, for the best reception without hav-
ing to handle the mobile phone.
To establish a connection with the vehicle's
external aerial:
●
Place your mobile device in the middle of
the pad with the screen facing up
›››
Fig. 196
›››
.
Make sure there are no objects between the
pad and the mobile phone.
Your mobile phone will automatically be
ready to make use of the external aerial.
WARNING
●
The mobile phone may heat up due to
the wireless charging. Think about this be-
fore you pick it up, and take care when re-
moving it.
●
There must be no metallic or other ob-
jects between the mobile phone and the
housing, to prevent the functionality of the
Connectivity Box from being affected.
Note
●
Your mobile device must support the Qi
inductive charging interface standard for
proper operation.
●
The charging time and the temperature
vary in accordance with the device used.
●
The maximum charging capacity is 5 W.
●
Qi technology does not allow you to
charge more than one mobile device simul-
taneously.
●
No improvement in reception can be
guaranteed if there is more than one mo-
bile phone on the pad.
●
You are advised to keep the engine run-
ning to guarantee proper wireless charging.
●
When a telephone with Qi technology is
connected by USB, it will be charged by the
means specified by the manufacturer.
225