Cupra ATECA, Owner'S Manual, Page: 211 / 380

Operating modes
Setup
Function button: function
INVERT
: Reverses the direction of the stored Offroad
tour.
NEXT POINT
: Starts the Offroad tour from the nearest
point.
Start
: Starts the complete Offroad tour.
When route guidance starts, the system
switches to the map view.
Stopping route guidance
●
Press the
OPTIONS
button on the screen
and then press
Stop
.
End waypoint navigation
●
Press the
Exit
function button in the Off-
road Navigation menu
WARNING
Terrain features are disregarded during
route guidance Drive slowly and following
the instructions in order to perform the
manoeuvre as far as possible!
●
The general direction of travel is indica-
ted straight ahead by direction arrows in
the Infotainment System pop-up window
›››
Fig. 174
A
.
Note
If an Offroad tour is being recorded, this is
automatically stored if Offroad navigation
is discontinued.
Vehicle Menu
Introduction to using the Vehicle
menu
By pressing button

of the infotainment
system you will access its main menu with
the following options:
●
VIEW
●
RADIO or MEDIA (to control playback in ra-
dio or media mode)
● HDC (displayed if the descent assistant is
active)
›››
page 239
●
PREVIOUS-NEXT (to change screen)
●
SETTINGS
›››
page 80
With the
View
function button you can ac-
cess the following information:
●
INSTRUMENT PANEL
›››
page 209
●
SPORT*
›››
page 210
●
OFFROAD*
›››
page 210
●
CONSUMERS
›››
page 211
●
DRIVING DATA
›››
page 211
● ECOTRAINER
›››
page 212
●
VEHICLE STATUS
›››
page 213
Instrument panel*
3
Valid for vehicles fitted with a Digital Cockpit
Fig. 175
Instrument panel
Press the
Instrument Panel
button to choose
from the various display options and cus-
tomise the information that appears in the
Digital Cockpit
›››
page 63
.
Automatic View
Pre-set information depending on the Driv-
ing mode.
Classic View
The needles are displayed at full length.
»
209