Cupra ATECA, Owner'S Manual, Page: 111 / 380

Lights
●
Never drive with daytime lights if the road
is not well lit due to weather or lighting
conditions.
●
On vehicles with rear lights with bulbs,
when activating the daytime running light
the rear lights are not switched on. A vehi-
cle which does not have the rear lights on
may not be visible to other drivers in the
darkness, in the case of heavy rain or in
conditions of poor visibility.
WARNING
If the headlights are set too high and not
used correctly, there is a risk of dazzling or
distracting other road users. This could re-
sult in a serious accident.
●
Always make sure that the headlights are
correctly adjusted.
Note
●
The legal requirements regarding the use
of vehicle lights in each country must be
observed.
●
The dipped beam headlights will only
work with the ignition on. The side lights
come on automatically when the ignition is
turned off.
Fog lights
Fig. 88
Dash panel: lights control.
The warning lamp

on the light control or
the instrument panel, also shows when the
fog lights are on.
●
Turning on the rear fog light

: pull the
light switch fully out
›››
Fig. 88
1
from posi-
tion

,

or

.
●
To switch off the fog lights, press the light
switch or turn it to position

.
Note
The rear fog light can dazzle drivers behind
you. You should use the rear fog light only
when visibility is very poor.
Turn signal and main beam lever
Fig. 89
Turn signal and main beam lever.
More the lever to the required position:
Right turn light or right-hand parking
light (ignition switched off).
Left turn light or left-hand parking light
(ignition switched off).
Main beam on: control lamp

lit up on
the instrument panel.
Light flash: on with the lever pushed.
Control lamp

lit up.
Push the lever all the way down to turn off
the corresponding function.
Convenience turn signals
When the ignition is switched on, move the
lever as far as possible upwards or down-
wards and release the lever. The turn signal
will flash three times.
»
1
2
3
4
109