Cupra ATECA, Owner'S Manual, Page: 252 / 380

Driving
CAUTION
For automatic switching off due to system
failures, for security reasons, the limiter is
only completely switched off when the
driver stops pressing the accelerator or
consciously switches it off.
Note
●
Different versions of the instrument pan-
el are available and therefore the versions
and instructions on the display may vary.
●
If the cruise control (GRA), the adaptive
cruise control (ACC) or the speed limiter
are connected when the ignition is switch-
ed off, the assistants will switch it when the
ignition is switched on, but only the speed
limiter will maintain the last programmed
speed.
Operating the speed limiter with the
turn signal lever
Fig. 208
On the turn signal lever: buttons to oper-
ate the speed limiter.
Connecting
●
Move control
›››
Fig. 208
1
to position

and press button
2
.
The last programmed speed is stored. It does
not take effect yet.
Activating the speed limiter
●
While driving, press button
›››
Fig. 208
3
in the area

.
The current speed is stored as the maximum
speed.
Setting the programmed speed
You can set the speed using button
›››
Fig. 208
3
:
● Briefly press area

to increase speed in
small increments of 1 km/h (1 mph).
●
Press and hold the area

to continu-
ously increase speed in increments of 10
km/h (5 mph).
●
Briefly press area

to decrease speed
in small increments of 1 km/h (1 mph).
● Press and hold area

to continuously
decrease speed in increments of 10 km/h (5
mph).
The speed is limited to the set value.
Switching off the speed limiter
●
Move control
›››
Fig. 208
1
to position

.
The system switches off.
Switching off temporarily
If you want to temporarily deactivate the
speed limiter, e.g. for overtaking, move the
control
›››
Fig. 208
1
to position

or
press button
2
.
After overtaking, the speed limiter can be
activated with the previously programmed
speed by pressing button
›››
Fig. 208
3
in
the area

.
250