Cupra ATECA, Owner'S Manual, Page: 250 / 380

Driving
Operating the cruise control
Fig. 206
On the turn signal lever: controls for op-
erating the GRA.
Connecting
● Move the control
›››
Fig. 206
1
to

.
If no speed has been programmed, the sys-
tem will not control it.
Activating the cruise control
●
Press button
›››
Fig. 206
2
in area

.
The current speed is stored and the cruise
control is activated.
Temporarily interrupting
●
Move the control
›››
Fig. 206
1
to

or
step on the brake.
The cruise control system is switched off
temporarily. The speed is stored.
Reinstating the cruise control
●
Press button
›››
Fig. 206
2
in area

.
Cruise control is activated at the stored
speed.
Adjusting the speed
While the GRA is set, the stored speed can
be adjusted with button
›››
Fig. 206
2
:
●
To increase in increments of 1 km/h (1
mph) briefly press button
›››
Fig. 206
2
in
the area

.
● To increase the speed without interrup-
tion, keep button
›››
Fig. 206
2
pressed
down in the area

.
●
To reduce in increments of 1 km/h (1 mph)
briefly press button
›››
Fig. 206
2
in the area

.
●
To reduce the speed without interruption,
keep button
›››
Fig. 206
2
pressed down in
the area

.
The vehicle adapts the current speed by ac-
celerating or stopping accelerating. The ve-
hicle does not brake actively.
Switching off
●
Move control
›››
Fig. 206
1
to

.
The system is disconnected and the memo-
rised speed is deleted.
Speed limiter
Control lamp

It lights up green
The speed limiter is switched on and active.
 Flashes green
The speed set by the speed limiter has been excee-
ded.

It lights up
The adaptive cruise control (ACC) or the speed limiter
is active.
The control lamps light up when the ignition
is switched on and should turn off after ap-
proximately 2 seconds. This is the time taken
for the function check.
WARNING
Observe the safety warnings
›››
in Con-
trol and warning lamps on page 79 .
248