23
Note : You need to enter interface numbers first before issuing below 2-15 commands.
2. Enable port auto-negotiation.
Command
Parameter
Description
Gateway(config-net-PORT-
PORT)# auto-negotiation
Set the selected interfaces’ to auto-
negotiation. When auto-negotiation is
enabled, speed configuration will be
ignored.
No command
Gateway(config-net-PORT-
PORT)# no auto-negotiation
Set auto-negotiation setting to the default
setting.
3. Enable port auto-negotiation.
Command
Parameter
Description
Gateway(config-net-PORT-
PORT)# combo-mode
[copper|fiber]
[copper|fiber] Specify combo port on copper or fiber
port.
No command
Gateway(config-net-PORT-
PORT)# no combo-mode
Disable combo mode.
4. Set up port duplex mode.
Command
Parameter
Description
Gateway(config-net-PORT-
PORT)# duplex [full]
[full]
Configure port duplex to
full.
No command
Gateway(config-net-PORT-
PORT)# no duplex
Configure port duplex to
half.
Note1 : Only copper ports can be
configured as half duplex.
Note2 : Auto-negotiation needs to be
disabled before configuring duplex
mode.
5. Enable flow control operation.
Command
Parameter
Description
Gateway(config-net-PORT-
PORT)# flowcontrol
Enable flow control on port(s).
No command
Gateway(config-net-PORT-
PORT)# no flowcontrol
Disable flow control on port(s).
6. Operation mode selection.
