![background image](http://html1.mh-extra.com/html/cpi/supercross-series/supercross-series_service-manual_2675025032.webp)
CARBURETOR
FL-8
FLOAT CHAMBER LEVEL
It is not possible to carry out the
following corrections with a Dell’Orto
carburetor as its float is entirely made of
plastic. In case of any defects in this part,
the float shall be replaced.
Dell'Orto
Level adjustment (Mikuni)
Measure the distance between the reference edge
of the carburetor float and the carburetor body (H)
with an alignment gauge.
For this purpose, hold the carburetor body in such
a position that the float is free and does not exert
any pressure on the needle valve.
The float must not face vertically up,
since then its weight exerts pressure on
the needle valve and a correct
adjustment is not possible.
Float standard level (H):
10 - 12 mm
H
Mikuni
If the measured value deviates from the default
value, the float chamber level must be adjusted by
bending the stop lug of the float into the desired
direction.
Note that only the position of the stop lug is to be
changed. Neither the holder plate nor the position
of the float hinge pin must be changed.
Stop lug (the position
of the holder plate and
of the float hinge pin
must not be changed!)
Slightly lift the float with your finger. There must
be sufficient clearance between the stop lug and
the needle valve below.
Adjust the clearance with a suitable tool into the
proper direction.
Summary of Contents for SuperCross Series
