High Speed Dome Camera Introduction Manual
32
▌▌
SOFT ADDRESS SET
The use can set up the SOFT ADDRESS, SOFT PROTOCOL and
SOFT BAUD RATE under this menu here to activate the soft address
function. And then the defined dome address by dip switch will be
disabled.
1. Move the cursor to INPUT (under DOME ID) and press
IRIS OPEN to enter the mode of setting dome ID, Move
the joystick to position the cursor beside :0 1 2 3 4 5 6 7 8
9” and press IRIS OPEN to enter. And move the joystick
again to select numbers of dome ID and press IRIS
OPEN to confirm. The number selected will be input on
the upper line.
2. Move the cursor to INPUT (the bottom menu) and press
IRIS OPEN to enter the mode of setting soft address,
Move the joystick to position the cursor beside :0 1 2 3 4
5 6 7 8 9” and press IRIS OPEN to enter. And move the
joystick again to select numbers of dome soft address
and press IRIS OPEN to confirm. The number selected
will be input on the upper line.
3. Enable or disable the soft address function. Press IRIS
CLOSE to exit last step. Move the cursor to
“SOFTADDRESS:ON/OFF”. Press iris open to enter.
Move the joystick up or down to select ON of OFF. Press
IRIS OPEN to confirm.
4. Press OK to save and confirm all the settings and press
CANCEL to exit all the settings.
