High Speed Dome Camera Introduction Manual
18
▌▌
Check points before operation
z
Before power is applied, please check the cables carefully.
z
The camera ID of the controller must be identical to that of the target camera. The camera ID can be
checked by reading DIP switch of the camera.
z
If your controller supports multi-protocols, the protocol must be changed to match to that of the
camera.
z
If you changed camera protocol by changing DIP switch, the change will be effective after you reboot
the camera.
z
Since the operation method can be different for each controller available, refer to the manual for your
controller if camera can not be controlled properly. The operation of this manual is based on the
standard Pelco® Controller.
▌▌
Preset and pattern Function Pre-Check
z
Check how to operate preset and pattern function with controller or DVR in advance to operate
camera function fully when using controller or DVR.
z
Refer to the following table when using standard Pelco® D protocol controller.
<Go Preset>
Press [Call] input [Preset number]and press [Enter]
<Set Preset>
Press [Preset] input [Preset number] and press [Enter]
<Run Pattern>
Press [Call] input [Pattern number] and press [Enter]
<Set Pattern>
Please refer to the pattern setup, turn to “Pattern Setup”
z
If controller or DVR has no pattern button or function, use shortcut keys with preset numbers. For
more information, refer to “Reserved Preset” in this manual.
▌▌
Starting OSD Menu
z
Function
Using the OSD menu, Preset, Pattern, Swing, Group Pan, Tilt and Alarm Input
function can be configured for each application.
z
Enter Menu
Press <Call> + Preset Number [95] +<Enter> (or call preset No.1 two times
continuously within two seconds)
z
Move/ Select Item Control the joystick to move the cursor around the menu
（
Move the joystick up
and down to select the item
z
Enter Item
Press “Iris Open” to enter the menu for selections
（
Press “Iris Open” to confirm
the selection
）
z
Quit from Menu
Press “Iris Close” to cancel the selection
*
Note
: If your controller does not have a joystick, use the up or down key.
