Activity detection can be started or stopped or activated as long as the input has
been activated (Start+Stop).
♦
Activity detection (Start+Stop) – to start activity detection for a certain timescale
and stop it again
♦
Activity detection (Start) – activate on impulse
♦
Activity detection (Stop) – deactivate on impulse
Be careful not to trigger an illogical sequence! – for example the event
„activity detected“ could trigger the action „deactivate activity detection“.
9.5 Configuring the Hard Disk (Convision V610 A
only)
9.5.1 Partitioning the Hard Disk
In the "Partition" menu, you can subdivide the hard disk in as many as 8 partitions.
There are 4 different types of partitions.
Long-time recording: The recordings are started either dependent on
time or via the user interface. Multiple cameras may record on one
partition.
Ring buffer: for recording pre and post event images.
Impulse controlled: for post event recordings in a preset time period.
Contact controlled: for recordings in a time period determined by a
trigger element, e.g. for as long as a motion detector signals
movements.
)
Note: Once you have set up a partition, you can no longer change its parameters.
You can, however, delete the partition and set up a new one. If you set up further
partitions later on, you must delete these first as well.
When setting up a partition, hard disk storage space is reserved for the images
according to the parameters you specify. If the images cannot be recorded at the
defined speed because the system is busy with other tasks, the recording procedure
is continued until the reserved storage space has been used. In this case, the
recording time is longer than originally defined.
If you want to set up a partition, the size of which exceeds the storage space
still available, the size of the partition will be limited to the remaining storage.
You will not see an error message but the partition will be smaller than
expected.
Manual
- 71 -
