Figure 36: Configuring the inputs – weekly schedule
4. If you want to have a set period of time between two events, click on “Time
between 2 Events“. A window will then pop up where you can enter a time in
seconds for each input. Here you can also define a minimum time an input signal
must be present, until it is interpreted as a signal. By default "0" each signal will
be interpreted. Save the data.
5. Save the data in the schedule window.
6. Return to the page, on which you can select the inputs. The configured and saved
inputs are now indicated by a clock symbol.
7. Click "Add" to select actions to be performed when this input receives a message.
8. A page will be displayed on which you can assign the event actions from various
groups.
9. You can assign any number of actions. All the actions will be listed in the table in
the line associated with the respective input.
10. Repeat steps 1 to 4 for other inputs, if desired.
11. Click "Delete" to cancel the assignment of actions.
12. Save the data.
)
Note: All the actions you want to trigger must first be configured. Clicking on the
actions opens the associated configuration pages. Check the status on these pages
to avoid assigning partitions that do not exist or messages that have not been written.
9.3.2 Key
Switch
The alarm inputs are activated using the key switch. Add actions here which should
be carried out whenever the key switch is switched on or off.
- 58 -
Convision V600 A Series