INS_CNGE11FX3TX8MS[POE][HO] Rev. 11.6.17 PAGE 12
INSTRUCTION MANUAL
CNGE11FX3TX8MS[POE][HO]
TECH SUPPORT: 1.888.678.9427
Power Supply
For CNGE11FX3TX8MS Models, Power Supply must be 12 to 57 VDC @ 15 W max.
For CNGE11FX3TX8MSPOE Model, Power Supply must be 44 to 57 VDC @ 255W max.
For CNGE11FX3TX8MSPOEHO Model, Power Supply must be 44 to 57 VDC @ 375W max.
IMPORTANT SAFEGUARDS:
A) Elevated Operating Ambient
- If installed in a closed or multi-unit rack assembly, the operating
ambient temperature of the rack environment may be greater than room ambient. Therefore,
consideration should be given to installing the equipment in an environment compatible with
the maximum ambient temperature (T
ma
) specified by the manufacturer.
B) Reduced Air Flow
- Installation of the equipment in a rack should be such that the amount of air
flow required for safe operation of the equipment is not compromised.
Front Panel LEDs
LED
Color
Status
Description
Alarm
Red
On
Alarm Fault Status has been triggered
Power 1 Alarm
Green
On
Power Input on VIN1 terminal block Input
Red
On
Power lost to VIN1 terminal block
Power 2 Alarm
Green
On
Power Input on VIN1 terminal block Input
Red
On
Power lost to VIN2 terminal block
PoE (Power over Ethernet)
30W A
Green
On
MODE A PoE is being supplied on indicated RJ-45 port
30W B
Green
On
MODE B PoE is being supplied on indicated RJ-45 port
Gigabit Ethernet ports
Link
Green
On
Port in Full Duplex mode
Activity
Amber
Blinking
Data transmitted
Gigabit SFP ports
Link/Activity
Amber
Blinking
Data transmitted
POEHO 60 W PoE Model
Port 1 to 4 support both mode A and mode B PoE which is 60 W in total. When a greater than 30
W PoE supported device is connected to ports 1 to 4, both 30 W A and B Indicator LEDs will be
turned on to indicate the high-power application device is connected.
