INS_CNGE11FX3TX8MS[POE][HO] Rev. 11.6.17 PAGE 82
INSTRUCTION MANUAL
CNGE11FX3TX8MS[POE][HO]
TECH SUPPORT: 1.888.678.9427
AAA
RADIUS
This page allows you to configure the RADIUS servers.
Object
Description
Global Configuration
Timeout
Timeout is the number of seconds, in the range 1 to 1000, to wait for a reply from a RADIUS
server before retransmitting the request.
Retransmit
Retransmit is the number of times, in the range 1 to 1000, a RADIUS request is retransmitted
to a server that is not responding. If the server has not responded after the last retransmit it
is considered to be dead.
Deadtime
Deadtime, which can be set to a number between 0 to 1440 minutes, is the period during
which the switch will not send new requests to a server that has failed to respond to a
previous request. This will stop the switch from continually trying to contact a server that it
has already determined as dead.
Setting the Deadtime to a value greater than 0 (zero) will enable this feature, but only if more
than one server has been configured.
Key
The secret key - up to 63 characters long - shared between the RADIUS server and the
switch.
NAS-IP-Address
(Attribute 4)
The IPv4 address to be used as attribute 4 in RADIUS Access-Request packets. If this field is
left blank, the IP address of the outgoing interface is used.
NAS-IPv6-Address
(Attribute 95)
The IPv6 address to be used as attribute 95 in RADIUS Access-Request packets. If this field is
left blank, the IP address of the outgoing interface is used.
NAS-Identifier
(Attribute 32)
The identifier - up to 253 characters long - to be used as attribute 32 in RADIUS Access-
Request packets. If this field is left blank, the NAS-Identifier is not included in the packet.
Server Configuration
Delete
To delete a RADIUS server entry, check this box. The entry will be deleted during the next
Save.
Hostname
The IP address or hostname of the RADIUS server.
Auth Port
The UDP port to use on the RADIUS server for authentication.
Acct Port
The UDP port to use on the RADIUS server for accounting.