INS_CNGE11FX3TX8MS[POE][HO] Rev. 11.6.17 PAGE 122
INSTRUCTION MANUAL
CNGE11FX3TX8MS[POE][HO]
TECH SUPPORT: 1.888.678.9427
Object
Description
Peer MEP
This is only used if the 'Unicast MAC' is configured to all zero. The Link Trace Target MAC will be
taken from the 'Unicast Peer MAC' configuration of this peer.
Unicast MAC
This is only used if NOT configured to all zero. This will be used as the Link Trace Target MAC. This
is the only way to configure a MIP as Target MAC.
Time To Live
This is the LTM PDU TTL value as described in Y.1731. This value is decremented each time
forwarded by a MIP. Will not be forwarded reaching zero.
Link Trace State
Transaction ID
The transaction id is incremented for each LTM send. This value is inserted the transmitted LTM
PDU and is expected to be received in the LTR PDU. Received LTR with wrong transaction id is
ignored. There are five transactions in one Link Trace activated.
Time To Live
This is the TTL value taken from the LTM received by the MIP/MEP sending this LTR - decremented
as if forwarded.
Mode
Indicating if is was a MEP/MIP sending this LTR.
Direction
Indicating if MEP/MIP sending this LTR is ingress/egress.
Forwarded
Indicating if MEP/MIP sending this LTR has forwarded the LTM.
Relay
The Relay action can be one of the following
MAC: The was a hit on the LT Target MAC
FDB: LTM is forwarded based on hit in the Filtering DB
MFDB: LTM is forwarded based on hit in the MIP CCM DB
Last MAC
The MAC identifying the last sender of the LBM causing this LTR - initiating MEP or previous MIP
forwarding.
Next MAC
The MAC identifying the next sender of the LBM causing this LTR - MIP forwarding or terminating
MEP.
Test Signal
Enable
Test Signal based on transmitting TST PDU can be enabled/disabled.
DEI
The DEI to be inserted as PCP bits in TAG (if any).
Priority
The priority to be inserted as PCP bits in TAG (if any).
Peer MEP
The TST frame destination MAC will be taken from the 'Unicast Peer MAC' configuration of this
peer.
Rate
The TST frame transmission bit rate - in Mega bits pr. second. Limit is 2.5Gbps. This is the bit rate
of a standard frame without any encapsulation. If 1 Mbps rate is selected in a EVC MEP, the added
tag will give a higher bitrate on the wire.
The TST frame transmission bit rate - in Mega bits pr. second. Limit is 400 Mbps. This is the bit
rate of a standard frame without any encapsulation. If 1 Mbps rate is selected in a EVC MEP, the
added tag will give a higher bitrate on the wire.
The TST frame transmission bit rate - in Mega bits pr. second. Limit is 400 Mbps. This is the bit
rate of a standard frame without any encapsulation. If 1 Mbps rate is selected in a EVC MEP, the
added tag will give a higher bitrate on the wire.
