COBHAM Sea Tel 9711-56 IMA C Band, Installation Manual

Page: 73 / 234

Sea Tel 9711-56 IMA Installation in 168” Radome
5-19
EAR Controlled - ECCN EAR99
29. Rotate the flexible
waveguide and harness up
over the top strut/Ku-Band
feed.
30. Attach flexible waveguide
section to the rigid
waveguide section using the
8 screws, flat washer
through the adjoined
flanges.
31. Install flat washer, lock
washer and hex nut on each
srcew and tighten all 8 hex
nuts to torque spec.
32. Install cable ties on the feed
harness to following the
cable path around the back
of the reflector to the ICU &
QOR Switch.
33. Route the C-Band feed
harness along the rigid
waveguide, around the
back/top of the reflector to
the right side where the ICU
and QOR Switch Box are
located.
34. Connect the C-Band feed
harness to QOR switch box
J4 connector and tighten
the retainer screws.
35. Connect the C-Band LNB
coax to S1A on the top of
the QOR switch box.
36. Remove the 4 nylock nuts
from the bolts that pass up
through the wood and lower
isolation plate.
37. Discard this hardware.