COBHAM Sea Tel 9711-56 IMA C Band, Installation Manual

Page: 71 / 234

Sea Tel 9711-56 IMA Installation in 168” Radome
5-17
EAR Controlled - ECCN EAR99
14. Using an open end wrench
on the underside of the
pallet and a wrench or
socket from the top, remove
the 4 Nyloc nuts on the bolts
that are up through the
pallet and spider legs.
15. Discard all of this shipping
hardware.
16. There is a ground strap
installed on the the Az
Post/Spider. When the Az
Post/Spider is installed on
the base frame this ground
strap should be orientated
FORWARD (opposite the
base hatch.
17. Open the GA Assembly Hardware Kit.
18. Set the Az Post/Spider on base frame (ground strap forward) and align the mounting
holes in the feet of the spider to the holes in the base pan.
19. Apply Loctite to the 8 spider mounting bolts.
20. Install all 8 of the bolts up through the base frame, base pan and foot of the spider
with a flat washer and hex nut on top.
21. Using an open end wrench on the underside of the base frame and a wrench or socket
from the top, tighten the 8 hex nuts to torque spec.
22. Unbolt the reflector brace
from the frame and remove
it from in front of the lower
section of the reflector.
23. Discard this hardware.