COBHAM Sea Tel 9711-56 IMA C Band, Installation Manual

Page: 57 / 234

Sea Tel 9711-56 IMA Installation in 168” Radome
5-3
EAR Controlled - ECCN EAR99
3. Bolt the eight 6 inch
feet to the under side
of the radome base
frame using the
hardware provided.
Loosely assemble all
feet before tightening
any of the bolts and
apply Loctite.
Temporarily remove
the support blocks, or
jacks, and set the base
frame down on the
assembly surface to
align the feet. Tighten
all the hardware to
specified torque. Raise
the base frame back up
onto the support
blocks or jacks.
4. Place the two base pan
pieces on the base
frame. Install the
mounting hardware in
the four pan mounting
holes.
5. Align the base pan
perimeter holes to the
mounting holes in the
base frame.
Note:
You may want to
temporarily insert bolts
in 8-12 equidistant
holes around the
perimeter of the base
pans to provide good
alignment throughout
the perimeter hole
pattern.
6. Apply Loctite to the
mounting hardware
and tighten. If
alignment bolts were
inserted around the
perimeter in the
previous step, remove
them now.