O P E R A T I N G M A N U A L
8 0 0 . 7 4 9 . 2 7 6 1
w w w . c o a c h c o m m . c o m
1 3
4. Connect RT cable and dry pair to cart.
Note:
The following steps are referenced in Figure 12 below.
4a.
Connect the red RT cable
to the “TOP RT SET” port on the Cart’s rear rack patch panel.
Note:
If using a second RT bracket, connect the blue RT cable to the “BOTTOM RT SET” port.
4b.
Connect stadium’s dry pair panel
to the corresponding “STADIUM DRY PAIR” ports on the rear patch panel.
5. Connect AC power and power on the cart.
5a.
Route an external power extension cord
through the Cart’s hatch and connect it to the main AC power cord in
the rear of the Cart. At a minimum, the cart requires one dedicated 15 amp 120V circuit.
WARNING:
DANGER! Users should exercise extreme care when working with electricity. Additional care
should be used when working with electricity outdoors in inclement weather. When working
outdoors or near water, always connect the system into a ground-fault interrupting circuit.
CAUTION:
Secure and protect any cords to prevent walkway hazards and potential contact with moisture.
5b.
Power on the Cart
via Master On/Off switch on the Cart’s rear panel. (See Figure 13.)
5c.
Confirm
that all devices on the front rack are powered on, including the AC power distribution unit, Control Unit(s),
and monitor.
Figure 12: Patch Panel RT Cable and Dry Pair Ports
(4a.) Connect RT
cable to rear Cart
panel.
(4b.) Connect dry pairs
to rear Cart panel.
(5b.) Power on the Cart.
Figure 13: Patch Panel Master On/Off Switch
