O P E R A T I N G M A N U A L
8 0 0 . 7 4 9 . 2 7 6 1
w w w . c o a c h c o m m . c o m
1 0 7
Using Dry Pair with Wireless Press Box (WPB2)
Use the following steps to set up and connect your press box system to your sideline system via stadium dry pair
connections.
1. Make connections as shown below.
2. Connect AC power for the wireless press box, then do the following:
A. Power on the wireless press box unit’s Uninterruptible Power Supply (UPS).
B. Power on the
press box
Control Units (CUs). Select Home or Away and allow the CCF to load. This will
configure the Press Box Radio Transceivers (RTs).
C. Power on the press box Radio Packs (RPs). Verify that the RPs’ active pairing is to the press box CU.
Note:
Press box RPs should be paired to both the secondary (bottom) sideline CU and the primary (top) press box
CU.
Tip:
RPs with dual pairing can switch the active pairing between Control Units with this shortcut: Hold down both
Function buttons for 5 seconds.
3. Connect to X-Ware.
A. Power on the press box tablet.
B. Launch the press box X-Ware.
INTERCONNECT:
CAT-5e (or greater) from
Wired Interface Panel
Wireless Press Box Unit (WPB2) Rear Panel
Stadium Dry Pair (RJ-14s)
Wired Interface Panel Rear
