00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09
343
13 Maintenance
13.9 Hydraulic system
67089
- Start the machine.
- Start the diesel engine.
- Let diesel engine run at min. no-load speed for
about 10 seconds.
- Stop the diesel engine.
- Observe the general warnings at the beginning
of the "Maintenance" chapter.
- Check the hydraulic tank oil level and top up if
necessary.
- Repeat this process until topping up is not nec-
essary any more following a check.
– Start the machine.
– Start the diesel engine.
– Set gearbox to neutral. (No gear engaged).
– Let machine run with the ground speed control
lever halfway actuated for about 2 minutes in both
directions of travel.
– Stop the diesel engine.
– Observe the general warnings at the beginning of
the "Maintenance" chapter.
– Check the hydraulic system oil level and top up if
necessary.
– Screw on a new fresh air filter element (1).
86525
13.9.3 Changing the hydraulic system oil / oil
filter / fresh air filter element DOMINATOR 130
To change the hydraulic oil of the lift hydraulic system,
turn the steering wheel to pump the oil out of the
hydraulic oil tank with the engine stopped.
– Park the machine on level ground.
– Lower the feeder as far as possible.
– Lower the reel all the way.
– Swing in unloading auger tube.
– Observe the general warnings at the beginning of
the "Maintenance" chapter.
Warning!
Contact with hot liquids or machine parts.
Danger of burns
– Wear suitable protective clothing.
– Let liquids or machine parts cool down.
– Comply with instructions.
