266
00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09
13 Maintenance
13.2 General Information
67089
11212
13.2.15 Unbalance
85487
13.2.16 Welding work on combine harvester
– Observe the general warnings at the beginning of
the "Maintenance" chapter.
– Disconnect the battery isolating switch.
– Disconnect the electrical connectors between the
engine wiring harness and the main wiring
harness.
– Remove the electronic plug-in modules from the
central terminal compartment.
– Disconnect radio and CB radio.
– Disconnect all cable connections (1) from the
alternator.
–
Always
connect the ground clamp of the welders
in the immediate vicinity
of the welding point.
5768
13.2.17 Putting the machine out of action
Before work is carried out on the machine, perform the
following steps:
– Stop the diesel engine.
– Apply parking brake.
– Remove the ignition key.
– Remove key of battery isolating switch.
– Wait for machine parts which run on have come to
a complete halt.
– Secure machine by wheel chocks.
– Ensure that the machine cannot be started by any
third persons.
Caution!
Uneven running of machine parts.
Machine damage and excessive wear.
– Remove dirt accumulations in rotating
machine parts regularly and thoroughly.
WARNING:
Overvoltage may occur during all electric
welding work on the machine.
Electronic unit damage.
– Carry out all work steps below.
– Connect the earth clamp of the welder in
the near vicinity of the area where the
welding is being carried out.
