Cisco Webex 800 Series, User Manual

Page: 44 / 130

Procedure
Step 1 To disengage the battery clip, gently use a fingernail to depress the clip towards the top of the phone.
Don’t pull up on or twist the clip. Don't use a tool, such as letter opener or screwdriver, to pry the
clip open. An incorrect prying action with a tool can break the battery clip. Caution
Step 2
Use your fingernail to lift the battery gently about an eighth of an inch (a few millimeters) out of the battery
compartment.
Step 3 Release the battery clip and grab the battery with your fingers.
Step 4 Use the battery tabs and battery compartment slots as a pivot point to raise the battery edge out the battery
compartment.
Don’t slide the battery across the battery compartment because this action may damage the contacts.
Warning
Step 5 Gently withdraw the battery tabs from the battery compartment slots and lift the battery out of the battery
compartment.
Make sure that no part of the battery drags across the battery contacts in the phone.
Warning
Battery Hot Swap for 860 Phones
The Cisco Webex Wireless Phone 860 and Cisco Webex Wireless Phone 860S have a hot swap feature that
allows you to continue to use your phone while you change a low battery. During a hot swap, the 860 internal
phone battery provides minimum power to allow the phone to remain on. Active use of the phone or anything
that increases the power draw during a swap may, in rare situations, cause the phone to power off.
After you remove the battery, you have 60 seconds to replace the battery before the phone starts to shut down.
Cisco Webex Wireless Phone 800 Series User Guide
34
Phone Setup
Battery Hot Swap for 860 Phones