Cisco Webex 800 Series, User Manual

Page: 49 / 130

Step 8 Tap Connect .
Add the Phone to a Nonbroadcast Wi-Fi Network
Follow these steps to add your phone to a Wi-Fi network that is hidden or not broadcast.
Before you begin
You need the following information about the Wi-Fi network:
• Network name or Service Set Identifier (SSID)
• Network security mode (None, PSK, EAP-TLS, EAP-TTLS, or PEAP)
• PIN or passkey for the security mode, if you use one
Procedure
Step 1 Swipe up from the bottom of the phone’s display to show the installed applications.
Step 2 Tap the Settings app.
Step 3
Select Network & internet > Wi-Fi .
Step 4 Tap
Add Network
.
Step 5 Enter the desired Wi-Fi Network name .
Step 6 Select the desired Security :
• For an open network, select None .
• For a PSK enabled Wi-Fi network, select WPA/WPA2- Personal and enter the enter the 8-63 ASCII or
64 HEX Password .
• For an EAP enabled Wi-Fi network, select WPA/WPA2-Enterprise .
Step 7 For an EAP-TLS, EAP-TTLS, or PEAP network, select the network EAP method : PEAP, TLS, or TTLS.
Step 8 For a network with an EAP-TLS security mode, select the desired CA certificate and User certificate .
Check with your administrator for the certificate type to select and also arrange to install the certificates on
your phone.
Step 9
For a network with an EAP-TTLS or PEAP security mode, select the Phase 2 authentication method and
CA certificate option to use, and then enter the Identity and Password .
Step 10 Under
Advanced options
, set
Hidden network
to
Yes
.
You can also set the
Proxy
and
IP settings
as required.
Step 11 Tap Save .
Cisco Webex Wireless Phone 800 Series User Guide
39
Phone Setup
Add the Phone to a Nonbroadcast Wi-Fi Network