Cisco Linksys WAG310G, User Manual

Page: 131 / 164

Management
3425-00669 Rev E 111
Local Gateway Access
To ensure the residential gateway’s security, you will be asked for your username
and password when you access the residential gateway’s web-based utility. The
default username and password are admin.
Gateway Username —Enter the default Gateway Username, admin.
Gateway Password —Cisco recommends that you change the default Gateway
Password, admin, to one of your choice.
Re-enter to Confirm —Enter the Gateway Password again to confirm.
Remote Gateway Access
Remote Management —To permit remote access of the Gateway, from outside the
local network, select Enabled. Otherwise, keep the default, Disabled.
Management Port —Enter the port number that will be open to outside access.
Management Protoco l—Select the appropriate protocol, HTTP or HTTPS.
Note : When you are in a remote location and wish to manage the Gateway, enter
https://<Internet_IP_address>:port or http://<Internet_IP_address>:port. Enter the
Gateway’s specific Internet IP address in place of <Internet_IP_address>, and enter
the Management Port number in place of the word port.
Remote User Name —Enter the login user name for remote management.
Remote User Password —Enter the login password for remote management.
IGMP
IGMP Proxy —IGMP (Internet Group Membership Protocol) Forwarding (Proxying)
is a system to improve multicasting for LAN-side clients. This should be set to
Enabled if your clients support it, otherwise, select Disabled .
IGMP Querier Version —Select: Version 1, Version 2 or Version 3.
Query Interval —Only valid when IGMP Forwarding is enabled, default is 125
seconds.
Querier Immediate Leave —Only valid when IGMP Forwarding is enabled, default
is enabled.
Note : IGMPv2 is turned on by default and v3 is supported. IGMP Snooping is
turned on by default for all bridges.