Cisco Linksys WAG310G, User Manual

Page: 41 / 164

ADSL
3425-00669 Rev E 21

ADSL2+ (Annex M).
Note : Contact your service provider if you are not sure which mode to use.
9 Click the Save Modulation button.
10 Click the Save PVC button.
Connection Type
From the ADSL screen (Basic or Advanced View), the Connection Type selected,
whether an Internet Protocol (IP) or Point-to-Point Protocol (PPP) connection, will
determine what additional IP or PPP settings will be required to complete your
configuration.
Determine the desired Connection Type from the following list of options; then
proceed to the applicable section for setup instructions:

IPoE (RFC2684 Bridged) (on page 21)

IPoA (RFC2684 Routed) (on page 23)

PPPoE (RFC 2516) (on page 24)

PPPoA (RFC 2364) (on page 26)

PPPoE (RFC 2364)-New Zealand (on page 28)
Notes :

For IP-over-Ethernet (IPoE), you can configure either DHCP or static IP
addressing.

For IP-over-ATM (IPoA), you can configure only static IP addressing.

Once an IP/PPP connection has been added it can be selected from the Select
PVC Connection drop-down box where the IP/PPP setting may be modified
and saved by clicking the Save Settings button at the bottom of the page or
may be deleted by clicking Delete Connection button.
IPoE (RFC2684 Bridged)
Complete the following steps to add an IPoE connection.
1 Navigate to the ADSL screen.
Path : Setup > ADSL