Cisco Linksys WAG310G, User Manual

Page: 32 / 164

Chapter 2 Installing the Residential Gateway
12 3425-00669 Rev E
The following illustration shows the location and dimensions of the wall-mounting
slots on the bottom of the residential gateway. Use the information on this page as a
guide for mounting your residential gateway to the wall.
Notes:

Mounting hardware illustrations are not true to scale.

Cisco is not responsible for damages incurred by insecure wall-mounting
hardware.
Follow these instructions:
1 Determine where you want to mount the residential gateway. Make sure that the
wall you use is smooth, flat, dry, and sturdy. Also make sure the location is
within reach of an electrical outlet.
2 Drill two holes into the wall. Make sure the holes are 54 mm (21. 3 inches) apart.
3 Insert a screw into each hole and leave 2 mm (0.8 inches) below the head
exposed.
4 Maneuver the residential gateway so two of the wall-mount slots line up with
the two screws.
5 Place the wall-mount slots over the screws and slide the residential gateway
down until the screws fit snugly into the wall-mount slots.